Civic L4-1.8L (2006)
15. Install the cover in the reverse order of removal, and note these items:
-
Reinitialize the ODS unit.
-
To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the clips, hooks,
and hook strips.
-
Replace any clips you removed with new ones (A). Install them with commercially available upholstery ring pliers (B).
-
Before installing the side airbag (C), make sure the reinforcing cloth (D) is fixed on the seat-back frame (E) securely.
-
Make sure the side airbag harness and ODS subharness (passenger's seat) are routed properly.
4-door
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
-
Check the operation of the driver's seat position sensor after any of these actions:
-
Driver's seat position sensor replacement
-
Cover plate (front side of driver's seat slide rail) replacement
-
Calibrate the ODS unit after any of the these actions:
-
Front passenger's seat replacement (including any seat components)
-
Replacement of the seat weight sensors
-
After a vehicle collision
NOTE:
-
Take care not to tear the seams or damage the seat covers.
-
On the passenger's seat, do not touch the ODS sensor in the seat-back pad, and keep it away from oil. Oil can corrode the sensor caution it to fail.
-
Put on gloves to protect your hands.
1. Remove the front seat.
2. Remove the headrest.
