Civic L4-1.8L (2006)
1.
Raise the vehicle on a lift.
2.
Remove the rear wheels.
3.
Remove both rear ABS wheel speed sensors.
4.
Inspect the rear ABS wheel speed sensors for damage.
GOOD, UNDAMAGED SENSOR:
EXAMPLE OF DAMAGED SENSOR:
If the tip of a sensor has any damage, do this:
^
Replace the corresponding rear hub bearing unit(s):
-
Refer to page 18-34 (with disc brakes) or 18-35 (with drum brakes) of the 2006-2008 Civic Service Manual, or
-
Online, enter keyword HUB, then select Rear Knuckle/Hub Bearing Unit Replacement from the list.
^
Remove the damaged sensor, and connect the new sensor to the wire harness.
^
Go to step 6 to install the new ABS wheel speed sensor.
If the tips of the sensors are OK, go to step 5.
5.
Inspect the ABS wheel speed sensor 0-rings: