honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Wheel Speed Sensor|Locations > < Recall 07V399000: Inspect Rear ABS Sensor/Wheel Bearing
Page 1
background image

Wheel Speed Sensor: All Technical Service Bulletins
Recall 07V399000: Inspect Rear ABS Sensor/Wheel Bearing

MAKE/MODELS:           MODEL/BUILD YEARS:      
     
Honda/Civic               2006-2007
 
MANUFACTURER: Honda (American Honda Motor Co.)   
 
NHTSA CAMPAIGN ID NUMBER: 07V399000  MFR'S REPORT DATE: August 30, 2007 

COMPONENT: Wheels 

POTENTIAL NUMBER OF UNITS AFFECTED: 182756 

SUMMARY: 
 On certain vehicles, the wheel speed sensor housing uses an o-ring seal to prevent leakage to or from the wheel bearing. If assembled improperly, the
o-ring may not seal properly allowing water to enter the wheel bearing and eventually cause damage to the bearing, especially in areas where use of road
salt is prevalent. If the driver continues to drive with this condition it is possible for the wheel bearing to become loose, which could cause the bearing to
fail. 

CONSEQUENCE: 
 This could cause a wheel to fall off of the vehicle, possibly resulting in a crash. 

REMEDY: 
 Dealers will inspect the rear abs sensors and wheel bearings for damaged parts and replace them free of charge. The recall is expected to begin on or
about September 17, 2007. Owners may contact Honda at 1-800-999-1009. 

NOTES: 
 Honda recall No. Q56. Customers may also contact The National Highway Traffic Safety Administration's Vehicle Safety Hotline at 1-888-327-4236
(TTY 1-800-424-9153), or go to http://www.safercar.gov.

Wheel Speed Sensor|Locations > < Recall 07V399000: Inspect Rear ABS Sensor/Wheel Bearing