Civic L4-1.8L (2006)
REPAIR PROCEDURE
NOTE:
^
Before you begin, make sure you know the SRS component locations, and that you read and understand the SRS precautions and procedures
explained in the service manual.
^
This procedure is in an outline form that you can also use as a checklist for the repair. If you need more details on the topics listed below,
bookmark them in the 2006-2010 Civic Service Manual, or view them online:
-
Battery Terminal Disconnection and Reconnection
-
Front Seat Removal/Installation
-
Driver's Dashboard Undercover Removal / Installation
-
Passenger's Dashboard Undercover Removal / Installation
-
Kick Panel Removal/Installation
-
Steering Joint Cover Removal/Installation
-
Center Console Removal/Installation
-
Rear Side Trim Panel Removal/Installation
-
Rear Seat Removal/Installation
-
Carpet Replacement
1. Do the battery terminal disconnection procedure, then wait at least 3 minutes.
2. Remove the front seats.
3. Remove the driver's and the passenger's dashboard undercovers.
4. Remove the driver's and the passenger's kick panels.
5. Remove the center console.
6. Remove the rear side trim panels.
7. Remove the rear seat-back and the rear seat cushion.
8. Remove the carpet.
9. Remove the floor wire harness, then install a new floor wire harness:
^
Refer to pages 22-50 thru 22-55 of the 2006-2010 Civic Service Manual, or
^
Online, enter keywords FLOOR WIRE, then select Floor Wire Harness and USB Harness (Left/Right branch) Connector and Harness Locations
(2-Door) from the list for the model you're working on.
NOTE:
^
Do not bend or twist the new wire harness excessively, and make sure it is not pinched or too loose in any areas.
^
Make sure all the connectors on the new wire harness are secured.
^
Replace any damaged interior trim clips.
10. Reinstall the carpet:
^
Do not wrinkle or twist the carpet.
