Civic L4-1.8L (2006)
5.
Remove the two power steering pump mounting bolts, then lower the pump so you can access the 20-mm sealing bolt.
6.
Remove and discard the original sealing bolt and its washer.
7.
Clean the sealer out of the block threads by running a pick tool or a toothbrush along the threads.
NOTE:
Pull any material from the threads out of the engine block. Do not push it in.
8.
Coat the sealing surface on the engine block with clean engine oil.
9.
Install a new sealing bolt and washer. Torque the sealing bolt to 34 N.m (25 lb-if).
10.
Reinstall the parts in the reverse order of removal.
Repair Procedure E
REPAIR PROCEDURE E - POWER STEERING PUMP LEAK
NOTE:
During an engine oil leak inspection, if you discover the power steering pump is leaking from the inlet pipe area, replace the inlet pipe, 0-ring, and
hose clamp.
1.
Drain the fluid from the power steering reservoir.
^
Refer to page 17-30 of the service manual, or
^
Online, enter keywords POWER FLUID, then select Power Steering Fluid Replacement from the list.
