Civic L4-1.8L (2006)
The normal warranty applies.
Operation Number:
125517
Flat Rate Time:
0.3 hour
Failed Part:
P/N 37820-RNA-325
Defect Code:
03214
Symptom Code:
03203
Skill Level:
Repair Technician
REPAIR PROCEDURE
1. Disconnect the 2P connector from ECT sensor 2. (The sensor is installed in the bottom of the radiator, on the driver's side of the vehicle.)
2. Check for corrosion or looseness of the electrical terminals on ECT sensor 2 and its 2P connector:
^
If all of the terminals are clean and tight, go to step 3.
^
If terminals on the sensor are corroded or loose, but the terminals in the 2P connector are clean and tight, replace EGI sensor 2, then go to step 3.
^
If the terminals in the 2P connector are loose or corroded, replace EGI sensor 2 and its wire harness, then go to step 3.
3. Update the PGM-FI software with the HDS. Refer to Service Bulletin 01-023, Updating Control Units/Modules.
Disclaimer
