Civic L4-1.8L (2006)
15.
Remove the three screws from the gauge control module.
16.
Disconnect the 36P connector from the gauge control module.
17.
Install the new gauge control module in the reverse order of removal.
18.
Follow the instructions on the HDS display to write the ODO value to the new gauge control module.
19.
Complete the applicable HDS immobilizer programming by selecting Replace ECM/PCM, or Replace Immobilizer Receiver/Control Unit in the
IMMOBI section of the HDS.
NOTE:
Use HDS software 2.002.006 or later.
20.
Clear any stored DTCs in the body electrical section with the HDS.
Disclaimer
