Civic L4-1.8L (2006)
Template ID:
06-007A
Skill Level:
Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone
Office. You must request consideration, and get a decision, before starting work.
REPAIR PROCEDURE
1.
Make sure you have the anti-theft code for the audio system and the navigation unit (if equipped).
2.
Turn the ignition switch to the LOCK (0) position.
3.
Disconnect the negative cable from the battery, then wait at least 3 minutes before you continue.
4.
Remove the front passenger's seat-back panel:
^
Push down at the top to release the top three hooks.
^
Tilt the panel out at the top to release the sides.
^
Lift the panel up and off the two lower clips.
5.
Pull back the seat-back cover from the left side bolster so you can access the ODS unit.
6.
Unplug the electrical connectors.
7.
Remove the mounting screws from the ODS unit, then gently remove the unit.
8.
Install the replacement ODS unit.
9.
Slip the seat-back cover over the ODS unit.
10.
Reinstall the seat-back panel.
11.
Reconnect the negative cable to the battery, then turn the ignition switch to the ON (II) position.
12.
Initialize the ODS unit. Refer to the HDS (Honda Diagnostic System), and follow the SRS on-screen procedures:
NOTE:
When calibrating the ODS, make sure you use a prepared weight of 55 to 77 lbs. (At 58 lbs, a full case of Honda Genuine Antifreeze/Coolant
Type 2 will serve this purpose.)
^
Select SRS.
^
Select Calibration.
^
Select ODS Unit Initialization.
^
Follow the screen prompts.
13.
Enter the anti-theft code for the audio system and the navigation unit (if equipped), then set the clock (if needed).
Disclaimer
