Civic L4-1.8L (2006)
Impact Sensor: Service and Repair
Side Impact Sensor (Second) Replacement
Side Impact Sensor (Second) Replacement
Removal
1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
2. Disconnect the appropriate side curtain airbag 2P connector.
3. Remove the rear seat and seat side holster.
4. Disconnect the floor wire harness 2P connector from the side impact sensor second).
5. Remove the Torx bolt (A) using a Torx T30 bit, then remove the side impact sensor second) (B).
Installation
1. Install the new side impact sensor second) with the Torx bolt (A) then connect floor wire harness 2P connector (B) to the side impact sensor
second).
2. Reconnect the negative cable to the battery.
3. After installing the side impact sensor second), confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come
on for about 6 seconds and then go off.
4. Reinstall all removed parts.
