Civic L4-1.8L (2006)
7.
Insert the guide pin tool into the ABS wheel speed sensor bolt hole until the shoulder of the tool contacts the ABS wheel speed sensor bracket.
NOTE:
To prevent 0-ring damage, the ABS wheel speed sensor must be installed with the guide pin tool.
8.
Insert the ABS wheel speed sensor and the guide pin into the knuckle assembly.
NOTE:
To ensure proper alignment when pushing the ABS wheel speed sensor into the knuckle housing, do not hold the sensor bracket during
installation; hold the sensor wire.
9.
Gently push and pull the ABS wheel speed sensor in and out to make sure the 0-ring is sliding properly in its housing. While you're doing this,
make sure the sensor doesn't come out of the knuckle assembly. If the sliding effort is too high, remove the ABS wheel speed sensor, inspect the
0-ring for damage, and do the installation process again.
10.
Remove the guide pin tool.
11.
Reinstall the bolt, and torque it to 9.8 N.m (7.2 ft-lb).
12.
Repeat steps 6 thru 11 to install the other rear ABS wheel speed sensor.
13.
Install the rear wheels, and lower the vehicle.
