Civic L4-1.8L (2006)
10.
Pull the switch wires until the connector is in the small end of the switch boot. Using about 10 inches of electrical tape, tape the wires to the boot
as shown.
11.
Install the new brake pedal position switch:
^
Press a new switch attaching ring into the hole on the brake pedal bracket.
*
^
Use your hand to lift up on the brake pedal, then insert the switch into the attaching ring until the* end of the switch touches the top of the
brake pedal. Twist the switch clockwise 1/8 turn to lock it into position.
NOTE:
When you lock the switch into position, the clearance for the pedal stop bracket automatically adjusts to 0.7 mm (0.028 in.).
