Civic L4-1.8L (2006)
3. Insert a 3.5 mm center punch into the hole in the cushion frame to position the spring washers, when tightening the Torx nuts (A). Begin with the
¨and tighten them in crisscross pattern in two or more steps.
4. Using the pin driver to position the spring washers, torque the Torx nuts in the sequence shown in two or more steps.
5. Make sure the gap between the spring washer (A) and the seat track (B) is more than 4 mm, as shown.
6. Reassemble the front passenger's seat cushion cover/pad.
7. Reinstall the front passenger's seat.
8. Reconnect the negative cable to the battery.
9. Calibrate the ODS unit.
10. After installing the front passenger's weight sensors, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should
come for about 6 seconds and then go off,
2-door
Removal
NOTE: Removal of the front passenger's weight sensors must be performed according to the precautions/procedures described at the beginning of the
SRS section.
