Civic L4-1.8L (2006)
16. With a hammer and the special tools, install a new front bearing in the drive end housing.
Alternator Brush Inspection
17. Measure the length of both brushes with a vernier caliper.
-
If either brush is shorter than the service limit, replace the rear housing assembly.
-
If the brush length is OK, go to step 18.
Rotor Slip Ring Test
18. Check for continuity between the slip rings (A).
-
If there is continuity, go to step 19.
-
If there is no continuity, replace the rotor assembly.
19. Check for no continuity between each slip ring (A) and the rotor (B) and the rotor shaft (C).
-
If there is no continuity, replace the rear housing assembly, and go to step 20.
