Civic L4-1.8L (2006)
-
If there is continuity, replace the rotor assembly.
Alternator Reassembly
20. If you removed the pulley, put the rotor in the drive end housing, then tighten its locknut to 111 N-m (11.3kgf.m, 81.7 lbf.ft).
21. Remove any grease or oil from the slip rings.
22. Push the brushes (A) in, then insert a pin or drill bit (B) (about 1.8 mm (0.77 in.) diameter) to hold them there.
23. Heat the rear bearing seat with a heat gun for about 5 minutes (129-140 degrees F, 50-60 degrees C).
24. Put the rear housing assembly (A) and drive end housing/rotor assembly (B) together, tighten the four through bolts (C), and pull out the pin (D).
25. After assembling the alternator, turn the pulley by hand to make sure the rotor turns smoothly and without noise.
26. Install the alternator and drive belt.
