Civic L4-1.8L (2006)
7. Remove the 6 mm brake disc retaining screws (A).
8. Remove the brake disc (B) from the hub.
NOTE: If the brake disc has clung to the hub. Screw two 8 x 1.25 mm bolts (C) into the brake disc to push it away from the hub. Turn each bolt
90 degrees at a time to prevent the brake disc from binding.
9. Check the front hub for damage and cracks.
10. Remove the cotter pin (A) from the tie-rod end ball joint, then remove the nut (B).
NOTE: During installation, install a new cotter pin after tightening the nut, and bend its end as shown.
11. Disconnect the tie-rod ball joint from the knuckle using the ball joint remover.
12. Remove the flange bolt (A) and flange nuts (B) from the lower arm (C).
NOTE: During installation, install a new flange bolt and new flange nuts. After lightly tightening all three fasteners, tighten them to the specified
torque beginning with the flange nuts.
