Civic L4-1.8L (2006)
2. Disconnect the brake line (A) from the wheel cylinder (B). Remove the rear brake assembly (C) from the knuckle.
3. Remove the wheel sensor (A), the O-ring (B), and the sensor harness (C) from the knuckle (D). Do not disconnect the wheel sensor connector.
NOTE: Use a new O-ring during reassembly.
4. Place a floor jack under the trailing arm to support it.
NOTE: Do not place the jack against the plate section of the lower arm. Be careful not to damage any suspension components.
5. Remove the flange bolt (A), and disconnect the upper arm (B) from the knuckle.
