Civic L4-1.8L (2006)
2. Remove the boot bands. Take care not to damage the boot and dynamic damper.
^
If the boot band is welded type (A), cut the boot band (B).
^
If the boot band is a double loop type (C), lift up the band bend (D), and push it into the clip (E).
^
If the boot band is a low profile type (F), pinch the boot band using the commercially available boot band pincers (G).
3. Make a mark (A) on each roller (B) and inboard joint (C) to identify the locations of rollers and grooves in the inboard joint. Then remove the
inboard joint on the shop towel (D). Be careful not to drop the rollers when separating them from the inboard joint.
4. Use a paint pen to make a mark (A) on the rollers (B) and spider (C) to identify the locations of the rollers on the spider, then remove the rollers.
NOTE: Do not engrave or scribe marks on the rolling surfaces.
5. Remove the circlip (D).
6. Mark (E) the spider (C) and driveshaft (F) to identify the position of the spider on the shaft.
7. Remove the spider (C).
