Civic L4-1.8L (2006)
4. Remove the hub bearing unit (A) and the O-ring (B).
5. Install the hub bearing unit in the reverse order of removal, and note these items:
^
Use a new O-ring during reassembly.
^
Tighten all mounting hardware to the specified torque values.
^
Before installing the brake drum, clean the matching surface of the hub bearing unit and inside of the brake drum.
^
Before installing the wheel, clean the mating surface of the brake drum and the inside of the wheel.
^
Check the wheel alignment, and adjust it if necessary.
Knuckle Replacement-Disc Brake Type
1. Remove the hub bearing unit.
2. Remove the splash guard (A).
3. Remove the wheel sensor (A), the O-ring (B), and the sensor harness (C) from the knuckle (D). Do not disconnect the wheel sensor connector.
NOTE: Use a new O-ring during reassembly.
4. Place a floor jack under the trailing arm to support it.