Civic L4-1.8L (2006)
6. Disconnect the A/T clutch pressure control solenoid valve A connector.
7. Measure the A/T clutch pressure control solenoid valve A resistance at the connector terminals.
Standard: 3 - 10 Ohms
^
If the resistance is out of standard, replace the A/T clutch pressure control solenoid valve A.
^
If the resistance is within the standard, go to step 8.
8. Connect a jumper wire from the negative battery terminal to the solenoid valve A connector terminal No. 2, and connect another jumper wire from
the positive battery terminal to the connector terminal No. 1.
^
If a clicking sound is heard, the valve is OK. Reconnect the connector, and install all removed parts.
^
If no clicking sound is heard, go to step 9.
9. Remove the mounting bolts and the A/T clutch pressure control solenoid valve A.
10. Remove the ATF pipe (B), ATF joint pipes (C), O-rings (D), and gasket (E).
11. Check the fluid passage of the solenoid valve for contamination.
12. Connect a jumper wire from the negative battery terminal to A/T clutch pressure control solenoid valve A connector terminal No. 2, and connect
another jumper wire from the positive battery terminal to the connector terminal No. 1. Make sure A/T clutch pressure control solenoid valve A
moves.
13. Disconnect one of the jumper wires and check valve movement at the fluid passage in the valve body mounting surface. If the valve binds or
moves sluggishly, or if the solenoid valve does not operate, replace the A/T clutch pressure control solenoid valve A.
14. Clean the mounting surfaces and fluid passages of the solenoid valve body and solenoid valve cover.
15. Install the new gasket on the transmission housing, and install the ATF pipe and ATF joint pipes.
16. Install the new O-rings over the ATF joint pipes.
17. Install the A/T clutch pressure control solenoid valve A.
