Civic L4-1.8L (2006)
9. Install the cover plate onto the motor with the internal coupler terminals aligned. Make sure the new cover plate boss is about 180 degrees out of
phase from the spur gear boss.
10. Install the four screws, and tighten them in a cross pattern until all are tight.
11. Before installing the wiper motor, connect the wiper motor 5P connector to the motor connector, and turn the ignition switch to ON (II).
12. Turn the wiper switch ON then OFF to return the wiper shafts to the park position.
13. Turn the ignition switch to LOCK (0).
14. Disconnect the wiper motor 5P connector from the wiper motor.
15. Reinstall the wiper linkage assembly into the vehicle, and reconnect the wiper motor 5P connector.
16. Verify the wiper motor operation and park position before reinstalling the wiper blades.
17. Reinstall the under-cowl panel, the cowl covers, and the windshield wiper arms.
Disclaimer
