Civic L4-1.8L (2006)
6. Before you install the new wiper motor, set it to its park position:
^
Connect the 5P connector to the motor.
^
Turn the ignition switch to ON (II).
^
Turn the wiper switch on and then off.
^
Turn the ignition switch to LOCK (0).
^
Disconnect the 5P connector from the motor.
7. Install the new wiper motor to the linkage with the new dust seal. Install the new joint ball seal on the link.
8. Position the new link on the wiper motor shaft as shown, then install the new nut, and torque it to 25 N.m (18.4 lb-ft).
9. Install the linkage parallel to the link, with the holes in the link and the rod aligned.
10. Reinstall the wiper linkage, and torque its bolts to 9.8 N.m (7.2 lb-ft).
