honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Doors - Electrical Problems On Driver's Side|Page 6302 > < Doors - Electrical Problems On Driver's Side|Page 6300
Page 8
background image

42.

Remove the plastic corrugated tube and tape to about 200 mm away from the terminals.

43.

Examine the terminals for corrosion. Replace any corroded terminals with splices according to the procedure in steps 16 through 20. Remember to
space the splices down the wires so they do not fully overlap.

44.

Reinstall the plastic corrugated tube and tape it securely with the insulating tape.

45.

Install the new boot over the harness.

Doors - Electrical Problems On Driver's Side|Page 6302 > < Doors - Electrical Problems On Driver's Side|Page 6300