honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Refrigerant|Testing and Inspection > < Environmental Impact Information
Page 1
background image

Refrigerant: Technician Safety Information

WARNING ! !

*

SHOULD HFC-134A CONTACT YOUR EYE(S), CONSULT A DOCTOR IMMEDIATELY.

*

DO NOT RUB THE AFFECTED EYE(S). INSTEAD, SPLASH QUANTITIES OF FRESH COLD WATER OVER THE AFFECTED
AREA TO GRADUALLY RAISE THE TEMPERATURE OF THE REFRIGERANT ABOVE THE FREEZING POINT.

*

OBTAIN PROPER MEDICAL TREATMENT AS SOON AS POSSIBLE.

*

SHOULD THE HFC-134A TOUCH THE SKIN, THE INJURY MUST BE TREATED THE SAME AS SKIN WHICH HAS BEEN
FROSTBITTEN OR FROZEN.

IMPORTANT:

*

Always wear safety goggles and protective gloves when working on refrigerant systems.

*

Beware of the danger of carbon monoxide fumes caused by running the engine.

*

Beware of discharged refrigerant in enclosed or improperly ventilated garages.

*

Always disconnect the negative battery cable and discharge and recover the refrigerant whenever repairing the air conditioning system.

CAUTION: Avoid breathing A/C Refrigerant-134a and lubricant vapor and mist. Exposure may irritate eyes, nose, and throat. To remove R-134a from

the A/C system, use service equipment certified to meet the requirements of SAE J2210 (R-134a recycling equipment). If accidental system
discharge occurs, ventilate the work area before resuming service. Additional health and safety information may be obtained from the
refrigerant and lubricant manufacturers.

IMPORTANT:

*

Do not mix R-12 refrigerant and R-134a refrigerant, even in the smallest amounts. R12 and R-134a are incompatible with each other. If the
refrigerants are mixed, compressor failure is likely to occur.

*

Use only the specified lubricant (PAG) for the R-134a A/C system and R-134a components. If you use lubricants other than those specified,
compressor failure is likely to occur. Coat all the fittings and the O-ring seals with clean 525 viscosity refrigerant oil in order to provide a
leak-proof seal and in order to aid in assembly and disassembly.

*

Do not store or heat the refrigerant containers above 52 °C (125 °F).

*

Do not heat a refrigerant container with an open flame. If the container must be warmed, place the bottom of the container in a pail of warm water.

*

Do NOT intentionally do the following to the refrigerant containers:
-

Drop

-

Puncture

-

Incinerate

*

Refrigerant will displace oxygen. Work in well ventilated areas in order to prevent suffocation.

*

Do NOT introduce compressed air to any refrigerant container or refrigerant component. Contamination will occur.

*

If you must carry a container of DOT CFR Refrigerant-134a in a vehicle, do not carry the refrigerant in the passenger compartment.

All of the Refrigerant-134a disposable, blue containers are shipped with a heavy metal screw cap in order to protect the valve and the safety plug of the
container from damage. Replace the cap after each use of the container in order to continue the protection.

Refrigerant|Testing and Inspection > < Environmental Impact Information