Civic L4-1668cc 1.7L SOHC MFI (2003)
Side Air Bag: Service and Repair
Airbags/Seat Belt Tensioner Deployment and Disposal
Deployment Tool Check Procedure
Deployment Tool Check
1. Connect the yellow clips to both switch protector handles on the tool; connect the tool to a battery.
2. Push the operation switch: green means the tool is OK; red means the tool is faulty.
3. Disconnect the battery and the yellow clips.
Deploying Airbags/Tensioner (Inside Vehicle)
Airbag Disposal
Special Tool Required
Deployment tool 07HAZ-SG00500
Before scrapping any airbags, side airbags, seat belt tensioners or seat belt buckle tensioners (including those in a whole vehicle to be scrapped), the
airbags, side airbags, seat belt tensioners or seat belt buckle tensioners must be deployed. If the vehicle is still within the warranty period, the Honda
District Service Manager must give approval and/or special instruction before deploying the airbags, side airbags, seat belt tensioners or seat belt buckle
tensioners. Only after the airbags, side airbags, seat belt tensioners or seat belt buckle tensioners have been deployed (as the result of vehicle collision,
for example), can they be scrapped. If the airbags, side airbags, seat belt tensioners and seat belt buckle tensioners appear intact (not deployed), treat
them with extreme caution. Follow this procedure.
Deploying Airbags In the vehicle
If an SRS equipped vehicle is to be entirely scrapped, its airbags, side airbags, seat belt tensioners and seat belt buckle tensioners should be deployed
while still in the vehicle. The airbags, side airbags, seat belt tensioners and seat belt buckle tensioners should not be considered as salvageable parts and
should never be installed in another vehicle.
1. Turn the ignition switch OFF, then disconnect the battery negative cable, and wait at least 3 minutes.
2. Confirm that each airbag, side airbag, and seat belt tensioner is securely mounted.
3. Confirm that the special tool is functioning properly by following the check procedure on the tool label.
Driver's Airbag:
4. Remove the access panel from the steering wheel (A), then disconnect the driver's airbag 4P connector (B) from the cable reel.
Front Passenger's Airbag:
