Civic L4-1668cc 1.7L SOHC MFI (2003)
14. With a hammer and the special tools, install a new front bearing in the drive-end housing.
Alternator Brush Inspection
15. Measure the length of both brushes with a vernier caliper.
-
If either brush is shorter than the service limit, replace the rear housing assembly.
-
If brush length is OK, go to step 16.
Rotor Slip Ring Test
16. Check that there is continuity between the slip rings(A).
-
If there is continuity, go to step 17.
-
If there is no continuity, replace the rotor assembly.
17. Check that there is no continuity between each slip ring (A) and the rotor (B) and the rotor shaft (C).
-
If there is no continuity, replace the rear housing assembly, go to step 18.
-
If there is continuity, replace the rotor assembly.
Alternator Reassembly
