Civic L4-1668cc 1.7L SOHC MFI (2003)
13.
Install the new ball joint into the knuckle.
14.
Install the thread protector onto the ball joint.
15.
Insert the base installer adapter B into the C-frame press.
16.
Position adapter A over the ball joint, and position adapter H and the C-frame press.
17.
Tighten the C-frame press to press the ball joint into the knuckle.
18.
Install the knuckle in the reverse order of removal, and note these items:
^
Be careful not to damage the ball joint boot when installing the knuckle.
^
Tighten all mounting hardware to the specified torque values.
^
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align
the nut by loosening it.
^
Install a new lock pin in the castle nut after torquing.
^
Use a new spindle nut.
^
Before installing the new spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake
the spindle nut shoulder against the driveshaft.
^
Before installing the wheel, clean the mating surface of the brake disc and the inside of the wheel.
19.
Check the wheel alignment.
Disclaimer
