Civic L4-1668cc 1.7L SOHC MFI (2003)
22. Press a new hub bearing unit (A) into the hub (B) using the special tools and a press.
23. Install the knuckle/hub/hub bearing unit in the reverse order of removal, and note these items:
-
Be careful not to damage the ball joint boot when installing the knuckle.
-
Tighten all mounting hardware to the specified torque values.
-
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align
the castle nut by loosening it.
-
Install a new lock pin on the castle nut after torquing.
-
Use a new spindle nut on reassembly.
-
Before installing the new spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake
the spindle nut shoulder against the driveshaft.
-
Before installing the brake disc, clean the mating surface of the front hub and the inside of the brake disc.
-
Before installing the wheel, clean the mating surface of the brake disc and the inside of the wheel.
-
Check the front wheel alignment, and adjust it if necessary.
