Civic CVCC L4-1488cc 1.5L EW1, EW3 (1985)
8.
Remove the entire breaker plate assembly (2 screws).
Breaker Plate Assembly
9.
Remove and discard the rubber cap, screws, rotor shaft, and thrust washer.
Distributor Housing
10.
Align the index mark on the distributor coupling with the one on the distributor housing.
Rotor Shaft Thrust Washer
11.
Install the new rotor shaft thrust washer; then, with the index marks still aligned, install the new rotor shaft so its flat side faces the same
direction as the index marks.
Breaker Plate Assembly
12.
Install the new rotor shaft screw and cap, the breaker plate assembly, then the vacuum advance diaphragm, using the two new screws supplied in
the kit.
