honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Oil and Filter Service|Page 1875 > < Oil and Filter Service|Page 1873
Page 4
background image

4. Run the engine for more than three minutes, then check for oil leakage.

OIL FILTER   

Replacement  

WARNING:
-

After the engine has been run, the exhaust pipe will be hot; be careful when working around the exhaust pipe.

-

Be careful when loosening the drain bolt while the engine is hot. Burns can result because the oil temperature is very high.

1. Remove the oil filter with the oil filter wrench.

2. Inspect the threads and rubber seal on the new filter. Wipe off the seat on the engine block, then apply a light coat of oil to the new filter's rubber

seal.

NOTE: Use only filters with a built-in bypass system.

3. Install the oil filter by hand.

Oil and Filter Service|Page 1875 > < Oil and Filter Service|Page 1873