Civic CX Hatchback L4-1590cc 1.6L SOHC MFI (1997)
Power Steering Valve: Service and Repair
Assembly
TOOL REQUIRED
-
07NAG-SR30900 Piston Seal Ring
-
07974-SA50200 Sleeve Seal Ring Sizing Tool
-
07749-0010000 Driver
-
07746-0010100 Attachment, 32 x 35 mm
-
07GAG-SD40100 Piston Seal Ring Guide
-
07GAG-SD40200 Piston Seal Ring Sizing Tool
NOTE:
-
Clean the disassembled parts with a solvent, and dry them with compressed air. Do not dip the rubber parts in a solvent.
-
Always replace the Wrings and rubber seals with new ones before assembly.
-
Apply the recommended power steering fluid to the parts indicated in the assembly procedures.
-
Do not allow dust, dirt, or other foreign materials to enter the power steering system.
-
Use the appropriate special tools where necessary.
1. Apply vinyl tape to the stepped portion of the pinion shaft, and coat the surface of the vinyl tape with the power steering fluid.
2. Install the backup ring with its tapered side as shown below.
3. Coat the inside surface of the new valve oil seal with power steering fluid.
