Civic DX Coupe L4-1590cc 1.6L SOHC MFI (1999)
5. Using vernier calipers, measure the thickness of each brake pad lining. The measurement does not include the pad backing plate thickness.
Brake Pad Thickness:
Standard: 8.5 - 9.5 mm (0.33 - 0.37 inch)
Service Limit: 1.6 mm (0.06 inch)
6. If the brake pad thickness is less than the service limit, replace the front pads as a set.
7. Clean the caliper thoroughly; remove any rust, and check for grooves and cracks.
8. Check the brake disc for damage and cracks.
9. Install the pad retainers.
10. Apply grease to the points indicated by the arrows in the following illustration:
NOTE: Use the pad grease included in the pad set or Molykote M77 grease, and apply a thin coat of grease evenly to the designated points.
-
Piston end and inner pad contact surface
-
Pad and caliper bracket contact surface
-
Outer pad and caliper body contact surface
