Civic DX Coupe L4-1590cc 1.6L SOHC MFI (1999)
3.
Use a diagonal cutter to cut away the side of the terminal boot as shown, and slide the boot down the wire.
NOTE:
Steps 4 thru 5 are done for each terminal shown, one at a time. Use caution not to twist or bend the terminals during removal. If you damage
the terminals or the distributor, replace the distributor subassembly.
4.
Center the terminal in the opening of the crimping tool, and carefully crimp the terminal by closing the tool completely.
5.
Slide the boot back down over the terminal. The open end will not cause a problem.
6.
Repeat steps 4 and 5 for the other two terminals.
7.
Reinstall the terminals. When reinstalling a terminal, do not insert it at an angle or wiggle it from side to side. This can spread the terminal and
cause a poor contact.
8.
Reassemble the distributor, install a new O-ring, and install it in the vehicle.
NOTE:
