Civic DX Coupe L4-1590cc 1.6L SOHC MFI (1999)
10. Check the front wheel hub for damage and cracks.
11. Remove the wheel sensor from the knuckle (for cars with ABS).
NOTE: Do not disconnect the wheel sensor connector. Use the special tool to separate the ball joints from the suspension or steering arm.
CAUTION: Be careful not to damage the ball joint boot.
12. Clean any dirt or grease off the ball joint.
13. Remove the cotter pin from the steering arm and remove the nut.
14. Apply grease to the special tool on the areas shown. This will ease installation of the tool and prevent damage to the pressure bolt threads.
15. Install a 10 mm hex nut on the ball joint. Be sure that the hex nut is flush with the ball joint pin end to prevent damage to the threaded end of the
ball joint.
16. Install the special tool as shown. Insert the jaws carefully, making sure you do not damage the ball joint boot. Adjust the jaw spacing by turning
the pressure bolt.
