honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Steering Gear > < Steering Column Lock|Locations|Page 6677
Page 1
background image

Steering Column Lock: Service and Repair

SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or service.

Remove:

1. Make sure you have the anti-theft code for the radio, then wire down the frequencies for the radio's preset buttons. ('99 model)
2. Disconnect the battery negative cable.
3. Remove the driver's dashboard lower cover and knee bolster.
4. Disconnect the 5P connector from the under-dash fuse/relay box and the 7P connector from the main wire harness.
5.Remove the steering column covers, then remove the mounting bolts and nuts from the steering column.
6. Lower the steering column assembly.

7. Center-punch each of the two shear bolts, then drill their heads off with a 5 mm (3/16 in) drill bit.

CAUTION:  Do not damage the steering lock body.

8. Remove the shear bolts and the steering lock assembly.

Installation:

1. Install the new steering lock assembly without the key inserted.
2. Loosely tighten the new shear bolts.
3. Insert the ignition key, and check for proper operation of the steering wheel lock and that the ignition key turns freely.

4. Tighten the shear bolts until the hex heads twist off.
5. Install in the reverse order of removal.
6. Enter the anti-theft code for the radio, then enter the customer's radio station presets.

Steering Gear > < Steering Column Lock|Locations|Page 6677