Civic DX Coupe L4-1590cc 1.6L SOHC MFI (1999)
16. Install the bearing separator on the gearbox housing as shown.
17. Set the gearbox in a press so the gear housing point upward, then press the cylinder end seal and steering rack out of the gearbox.
NOTE: Hold the steering rack to keep it from falling when pressed clear.
CAUTION:
-
Be careful not damage to inner surface of the cylinder housing with the flange bolt.
-
Do not place your fingers under the steering rack.
18. Remove the 12 mm bolt and nut from the steering rack.
19. Remove the cylinder end seal from the steering rack.
20. Insert a 24" long, 3/8" drive extension and the special tool into the cylinder from the gearbox side.
NOTE: Make sure that the special tool is securely positioned on the backup ring edges.
CAUTION: Be careful not damage to inner surface of the cylinder housing with the special tool.
