honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Trailing Arm > < Removal and Replacement Strut|Page 6832
Page 9
background image

6. Hold the damper shaft with a hex wrench and tighten the self-locking nut.

INSTALLATION 

1. Lower the rear suspension, and position the damper with the spring stop pointed toward the left side of the vehicle.

2. Loosely install the two flange nuts.

3. Loosely install the flange bolt.
4. Raise the rear suspension with a floor jack until the vehicle just lifts off the safety stand. 

WARNING:  The floor jack must be securely positioned or personal injury may result.

5. Tighten the flange bolt.
6. Tighten the two flange nuts on top of the damper to the specified torque.
7. Check the rear wheel alignment and adjust if necessary.

Trailing Arm > < Removal and Replacement Strut|Page 6832