Civic DX Hatchback L4-1590cc 1.6L SOHC MFI (1997)
3. Remove the access panel, then disconnect the 2P connector between the driver's airbag and the cable reel.
4. Cut off the airbag connector, strip the ends of the airbag wires, and connect the deployment tool alligator clips to the airbag. Place the deployment
tool at least thirty feet (10 meters) away from the airbag.
5. Connect a 12 volt battery to the tool:
-
If the green light on the tool comes on, the air-bag igniter circuit is defective and cannot deploy the airbag. Go to Damaged Airbag Special
Procedure.
-
If the red light on the tool comes on, the airbag is ready to be deployed.
6. Push the tool's deployment switch. The airbag should deploy (deployment is both highly audible and visible; a loud noise and rapid inflation of the
bag, followed by slow deflation).
-
If the airbags deploy and the green light on the tool comes on, continue with this procedure.
-
If an airbag doesn't deploy, yet the green light comes ON, its igniter is defective. Go to Damaged Airbag Special Procedure.
WARNING: During deployment, the airbag assembly can become hot enough to burn you. Wait thirty minutes after deployment before
touching the assembly.
7. Dispose of the complete airbag assembly. No part of it can be reused. Place it in a sturdy plastic bag, and seal it securely.
CAUTION:
-
Wear a face shield and gloves when handling a deployed airbag.
-
Wash your hands and rinse them well with water after handling a deployed airbag.
