honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Engine Controls - MIL ON with 'Unknown' DTC Set|Page 4846 > < Engine Controls - Occasional Stalling When Stopping|Page 4841
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - MIL ON with 'Unknown' DTC Set

03-077

October 24, 2003

Applies To: 
2001-02 Civic DX, HX, LX, and EX - ALL

MIL Is On With "Unknown" DTC

SYMPTOM

The MIL is on, and when you try to retrieve the DTC with the HDS, "Unknown" is displayed.

PROBABLE CAUSE

The ECM/PCM software does not properly communicate the DTC to the HDS. When this happens, "Unknown" is displayed on the HDS screen.

CORRECTIVE ACTION

Use the Honda Interface Module (with September 2003 or later software) to update the ECM/PCM.

WARRANTY CLAIM INFORMATION

In warranty: The normal warranty applies.

Operation Number:

123503

Flat Rate Time:

0.3 hour

Failed Part:

P/N 37820-PLR-L55 
H/C 7064371

Defect Code:

03214

Symptom Code:

03203

Template ID:

03-077A

Skill Level:

Repair Technician

Out of warranty: 
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone
Office. You must request consideration, and get a decision, before starting work.

REPAIR PROCEDURE

1.

If not already done, load the September 2003 or later iN (Interactive Network) CD onto the iN master terminal. Loading instructions are included
in the CD's mailing.

2.

Update the ECM/PCM with the Honda Interface Module (HIM). For instructions, refer to Service Bulletin 01-023, Using the Honda Interface
Module to Update Control Units/Modules.

3.

Check if the MIL comes on:

^

If the MIL comes on, retrieve the DTC(s), and do the appropriate troubleshooting.

^

If the MIL stays off, return the vehicle to the customer.

Engine Controls - MIL ON with 'Unknown' DTC Set|Page 4846 > < Engine Controls - Occasional Stalling When Stopping|Page 4841