Civic EX Sedan L4-1668cc 1.7L SOHC (VTEC) MFI (2001)
_mfi/Page-371010.png)
on.
9.
When the SRS indicator goes off, unplug the SCS service connector from the 2P MES connector within 4 seconds.
10.
Watch the SRS indicator:
^
If the indicator blinks twice and then goes oft, the OPDS is initialized. Turn the ignition switch to LOCK (0), and disconnect the PGM Tester.
Go to step 19.
^
If the indicator blinks twice and then stays on, the OPDS is initialized, but the SRS DTCs need to be cleared. Go to step 11.
^
If the indicator stays on without first blinking, the OPDS is not initialized. Repeat steps 3 thru 10.
11.
Turn the ignition switch to LOCK (0), and disconnect the PGM Tester.
12.
Plug the SCS service connector into the 2P MES connector. Do not use a jumper wire.
13.
Turn the ignition switch to ON (II).
14.
Watch the SRS indicator. It comes on for about 6 seconds and goes off. Unplug the SCS service connector from the 2P MES connector within 4
seconds after the indicator goes off.
15.
When the SRS indicator comes on again, plug the SCS service connector into the 2P MES connector within 4 seconds after the indicator comes
on.
16.
When the SRS indicator goes off, unplug the SCS service connector from the 2P MES connector within 4 seconds. The SRS indicator blinks twice
to indicate that the memory has been cleared.
17.
Turn the ignition switch to LOCK (0), and wait for 10 seconds.
15.
Turn the ignition switch to ON (II). The SRS is OK if the SRS indicator comes on for 6 seconds and then goes oft. If the initialization fails, repeat
the process two more times. If the initialization fails again, check for set SRS DTCs, and troubleshoot in accordance with the appropriate service
manual.
19.
Do the idle learn procedure:
^
Make sure all electrical items (A/C, audio unit, defogger, lights, etc.) are turned oft, then start the engine.
^
Let the engine reach its normal operating temperature (the cooling fan cycles twice).
^
Let the engine idle (throttle fully closed and with all electrical items off) for 10 minutes.
20.
Civic 2-door EX, LX models: Do the cruise control learn procedure:
^
Drive the vehicle, and set the cruise control above 40 miles per hour.
^
Keep driving the vehicle for 5 to 10 minutes.
NOTE:
You can use a smog/chassis dynamometer to do this step instead of driving the vehicle. Do not do this step with the vehicle on a lift.
21.
CR-V models: Initialize the driver's window auto-up feature:
^
Turn the ignition switch to ON (II).
^
Make sure the driver's window is fully closed.
^
Push down and hold the window switch. Make sure the window goes all the way down.
^
Pull back and hold the window switch. Make sure the window goes all the way up, then hold the switch for at least 2 more seconds.
22.
Enter the anti-theft code for the radio and for the navigation system (if equipped) Enter your customer's radio station presets. Set the clock.
