Civic EX Sedan L4-1668cc 1.7L SOHC (VTEC) MFI (2001)
_mfi/Page-2200003.png)
8. Remove the flange bolt (A) and wheel sensor (B) from the knuckle. Do not disconnect the wheel sensor connector.
9. Remove the flange nut (A) while holding the joint pin (B) with a hex wrench (C), and disconnect the stabilizer link (D) from the lower arm (E).
10. Remove the lock pin (A) from the lower arm ball joint, and remove the castle nut (B).
NOTE: During installation, insert the lock pin into the ball joint pin in the range of 180 degrees or below from the inside of the vehicle. Insert
the lock pin from the inside to the outside of the vehicle.
11. Disconnect the lower arm from the knuckle using the special too.
