Civic EX Sedan L4-1668cc 1.7L SOHC (VTEC) MFI (2001)
INSPECTION PROCEDURE
1.
*Raise the vehicle on a lift.
2.
Inspect the lower front bushings on both rear knuckles.
^
If the bushings have a rubber collar, and the rubber collar overhangs on either knuckle, the rubber has worn away or deteriorated. Go to
REPAIR PROCEDURE.
^
If the bushings have a rubber collar, and the rubber collar is flush with each knuckle, the bushing is OK. Look for other possible causes for the
noise.
^
If the bushings have a steel collar, and you suspect them to be the source of the noise, disregard this service bulletin. Refer to page 18-26 of the
2001-03 Civic Service Manual, and replace the rear knuckles.
NOTICE
Do not attempt the repair procedure in this service bulletin if the bushings have a steel collar. Attempting to remove a steel-collared bushing
from the rear knuckle with the special tool would damage the tool and the knuckle.*
REPAIR PROCEDURE
1.
Remove the rear wheel.