Civic GX Sedan L4-1.6L CNG (1998)
Impact Sensor: Service and Repair
Front Impact Sensor
Removal
CAUTION:
-
Removal of the airbag must be performed according to the precautions/procedures described before.
-
Before disconnecting the side impact sensor 2P connector(s), disconnect the driver's and front passenger's airbag 2P, both seal belt tensioner 2P
and both seat belt buckle tensioner 2P connector(s).
-
Do not turn the ignition switch ON (II) and do not connect the battery cable while replacing the side impact sensor.
1. Disconnect the negative battery cable, and wait at least 3 minutes before beginning work.
2. Remove the front inner fender.
3. Disconnect the engine compartment wire harness 2P connector (A), and remove the two Torx bolts (B) using a Torx T30 bit, then remove the front
sensor (C).
Installation
CAUTION:
-
Be sure to install the harness wires so that they are not pinched or interfering with other parts.
-
Do not turn the ignition switch ON (II) and do not connect the battery cable while replacing the side impact sensor.
1. Install the new front sensor with new Torx bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front sensor (C).
2. Reconnect the negative battery cable.
3. After installing the front sensor, confirm proper system operation; Turn the ignition switch ON (II): the SRS indicator light should come on for
about 6 seconds and then go off.
