Civic Hatchback L4-1.5L SOHC (16 valve) (1995)
/Page-997007.png)
3. Fill the modulator reservoir to the MAX level line and install the reservoir cap.
4. Start the engine and allow it to idle for a few minutes, then stop it. Check the fluid level in the modulator reservoir and refill to the MAX level line
if necessary.
5. Bleed high-pressure fluid from the maintenance bleeder with the special tool.
6. Refill the modulator reservoir to the MAX level line and install the reservoir cap.
7. Turn the Mode Selector switch of the checker to 2.
8. While depressing the brake pedal firmly, push the Start Test switch to operate the modulator. There should be kickback on the brake pedal. If not,
repeat steps 5 to 8.
NOTE: Continue to depress the brake pedal firmly when operating the checker.
9. Turn the Mode Selector to 3, 4, and 5. Perform step 8 for each of the test mode positions.
10. Refill the modulator reservoir to the MAX level line and install the reservoir cap.
WARNING: Disconnect the ALB check before driving the car. A collision can result from a reduction, or complete loss of braking ability
causing severe personal injury or death.
