Civic Hatchback L4-1.5L SOHC (VTEC) (1995)
/Page-1597002.png)
CAUTION: All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, connect the short
connectors. Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags
could accidentally deploy and cause damage or injuries.
1. Remove the dashboard lower cover and steering column covers.
2. Disconnect the 4-P and 7-P connectors from the switch.
3. Check the connector terminals to be sure they are all making good contact. If the terminals are bent, loose, or corroded, repair them as necessary,
and recheck the system.
4. Check for continuity between the terminals in each switch position according to the table.
