Civic Hatchback L4-1493cc 1.5L SOHC (D15B1) TBI (1990)
_tbi/Page-462001.png)
Ignition Switch Lock Cylinder: Service and Repair
REMOVAL
1.
On models equipped with airbag, disarm airbag as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2.
On all models, disconnect battery ground cable.
3.
Remove ignition switch as described under STARTING AND CHARGING SYSTEMS/COMPONENT REPLACEMENT AND REPAIR
PROCEDURES/IGNITION SWITCH.
4.
Remove key light case from lock body, if equipped.
5.
On 1989 Accord models, place ignition lock cylinder in the ACC position.
6.
On except 1989 Accord, place ignition lock in the I position.
7.
On all models, position suitable punch into hole on lock cylinder housing and depress pin, then remove lock cylinder from housing.
INSTALLATION
1.
On 1989 Accord models, install ignition lock cylinder as follows:
a. Place ignition lock cylinder in the LOCK position.
b. Rotate key until it is almost at the ACC position, then insert lock cylinder until pin contacts housing.
c. Rotate key to ACC position, then push pin in and insert lock cylinder into housing until pin clicks into place.
2.
On except 1989 Accord, install ignition lock cylinder as follows:
a. Place ignition lock cylinder in the O position.
b. Rotate key until it is almost at the I position, then insert lock cylinder until pin contacts housing.
c. Rotate key to I position, then push pin in and insert lock cylinder into housing until pin clicks into place.
3.
Install ignition switch and connect battery ground cable.
