Civic LX Sedan L4-1590cc 1.6L SOHC MFI (1998)
4. Lubricate the caliper and piston with brake fluid, then install the piston in the cylinder with the dished end facing in.
5. Apply the recommended seal grease in the caliper seal set to the sliding surface of the pins and the inside of the new pin boots.
6. Install the pin boots into the grooves in the caliper bracket properly.
7. Insert pin A and pin B into the caliper bracket.
8. Install the pin boots into the grooves in the pins properly.
9. Install the brake pads in their original positions.
10. Push in the piston so that the caliper will fit over the pads, and install the caliper.
11. Tighten the caliper bolts.
12. Connect the brake hose to the caliper with new sealing washers, and tighten the banjo bolt.
13. Fill the brake reservoir and bleed the brake system.
14. Perform the following checks.
-
Check for leaks at hose and line joints and connections, and retighten if necessary.
-
Check for brake hoses for interference and twisting.
Type 2056
