Civic LX Sedan L4-1590cc 1.6L SOHC MFI (1998)
23. Remove the cotter pin from the upper ball joint castle nut, and remove the nut.
24. Install the 12 mm hex nut on the ball joint. Be sure that the hex nut is flush with the ball joint pin end, or the threaded section of the ball joint pin
might be damaged by the ball joint remover.
25. Use the special tool to separate the ball joint and knuckle.
NOTE: If necessary, apply penetrating type lubricant to loosen the ball joint.
26. Pull the knuckle outward and remove the driveshaft outboard joint from the knuckle by tapping the driveshaft end with a plastic hammer, then
remove the knuckle.
NOTE: Replace the bearing with a new one after removal.
27. Separate the wheel hub from the knuckle using the special tools and a hydraulic press.
CAUTION:
-
Take care not to distort the splash guard.
-
Hold onto the wheel hub to keep it from falling when pressed clear.
-
To prevent damage to the tool, make sure the threads are fully engaged before pressing.
