honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Front Windows - Bind or Out of Run Channel|Page 9468 > < Front Windows - Bind or Out of Run Channel|Page 9466
Page 3
background image

3.

Carefully move the glass until you can see the glass mounting bolts, then loosen them. Slide the guide rearward, remove the glass from the guide,
and carefully pull the glass out through the window slot.

4.

Check the year and VIN.

^

If the vehicle is a 1996 or 1997 within the affected VIN range, replace the window regulator. Go to step 5.

^

If the vehicle is not a 1996 or 1997 within the affected VIN range, go to step 8.

5.

Remove the two roller guide bolts and the two rear regulator mounting bolts; then remove the front regulator mounting bolts.

6.

Disconnect the power window motor connector, and detach the harness clip (it applicable); then lift and remove the regulator through the opening
in the door.

7.

Install the new regulator in the door, then loosely install the two rear mounting bolts and the two roller guide bolts. Do not tighten the two front
mounting bolts yet. Go to step 9.

8.

Loosen the window regulator's two rear mounting bolts, two front mounting bolts, and two roller guide bolts.

Front Windows - Bind or Out of Run Channel|Page 9468 > < Front Windows - Bind or Out of Run Channel|Page 9466