honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Multiplex Control System Troubleshooting|Page 9415 > < Multiplex Control System Troubleshooting|Page 9413
Page 3
background image

9. Troubleshoot the DTC(s) in the order indicated using the shown charts.

If a faulty control unit is suspected, substitute it with a known good part and recheck for DTCs.

-

If the DTC(s) is still present, go to the next step instead for the DTC.

-

If the DTC(s) is no longer present, replace the original part.

Note:  Before replacing a Faulty ECM/PCM make sure it has the latest software revision. Update if necessary before swapping or replacing.

Made 2 Test

1. From Mode 1, disconnect the special tool from the multiplex inspection connector for 5 to 10 seconds, and then reconnect it.
2. The spotlight and ceiling light should come on for 2 seconds, go out, then blink twice, 0.2 seconds each time. The system is now in mode 2.

Multiplex Control System Troubleshooting|Page 9415 > < Multiplex Control System Troubleshooting|Page 9413