honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Blower Unit|Page 7369 > < Diagram Information and Instructions|Page 7366
Page 1
background image

Blower Motor: Service and Repair
Blower Unit

SRS Main Harness

CAUTION: All SRS electrical wiring harnesses are covered with yellow outer insulation. Before disconnecting the SRS wire harness, install
the short connector (5) on the airbag (5). Replace the entire affected SRS harness assembly it it has an open circuit or damaged wiring.

1. Disconnect the battery negative terminal.

2. Remove the glove box and glove box frame.

3. Remove the tapping screws (2) and remove the heater duct.

Blower Unit|Page 7369 > < Diagram Information and Instructions|Page 7366